or
if you wish to post a topic here

feedback compensation: transconductance vs voltage error amplifier in smps?

Hello, The closed loop small signal feedback transfer function of a smps with a transconductance error amplifier includes a term which de...
0replies started by satcom

Charge-pump Voltage Doubler

Hi all, It would be very helpful if somebody review my explanation about the operation of this ideal voltage doubler based on charge pump s...
0replies started by satcom

Circuit of atta maker

Hi all, I am new in electronics. As part of some projects we are planning to make one circuit for atta maker. But while searching we did no...
0replies started by satcom

Reasons for using a DDS instead an FPGA + DAC

A question to the experts. I have the chance for upgrading a system. In the old one a dedicated complex FGPA + DDS is used and now I am wo...
0replies started by satcom

power supply 48v for condenser microphone

Can anyone help me? I want to have a voltage supply to my condensor microphone 48v from 2 AA Batteries. Thank you. ...
0replies started by satcom

laptop power supply with PIC

But with it, the PIC board cannot get on , just comes the power LED and goes off and then one off ....... I think the load of the PIC board...
0replies started by satcom

countdown timer on battery charger IC chip design

concerning principles of counters I don't have much information, so please suggest me some books and any books for digital IC design is OK ...
0replies started by satcom

What is the input capacitance of JFET at 150 Mhz?

I have some few doubts and I want you to clear those. I want to know the input parasitic capacitance of JFET at 150 Mhz ( the jfet I am usi...
0replies started by satcom

Full-Bridge SMPS vs Phase-shift-Full-Bridge SMPS?

Hello, We need to do a 700W offline converter. We are decidning between phase shift full bridge and plain full bridge. It appears that the ...
0replies started by satcom

please help me for this desigin and simulation with Hspice

I want design an Op-Amp by following specification and simulate with hspice. please help me. - Fully Differential - VDD=1.8 V Single supply...
0replies started by satcom